Not only will regular maintenance by a Laser Repair Technician maintain your system safe and secure, but it
will also save you money by preventing laser damage and downtime, resulting in
efficient treatments for your clients. Keep in mind that owning and managing an
attractive laser system involves considerable responsibility. Its upkeep is
essential for your organization, you, and your customers.
Maintenance Advice for Aesthetic Lasers
Daily Cooling System Check
The cooling system also requires daily inspections
before you activate the laser to prevent overheating. Check the cooling system
levels before operating the laser equipment. Make careful you use deionized
water and a coolant additive if necessary. The laser cavity and, in certain
situations, the power supply, and handpieces are cooled by the coolant system.
Your system might overheat if you neglect to monitor the water cavity.
Dust filters
Filters, vents on side panels, and fans should all be
periodically dusted and vacuumed. The main cause of electrical and optical
failures is dust. Dust and debris hinder your aesthetic laser from cooling down
correctly, which might result in component and electrical damage. Cleaning the
areas where you utilize the laser can help stop the future buildup of junk on
the filter and vents. You can opt for Lumenis Repair.
Not Filling Laser Equipment Too Much
Make sure you're using deionized or distilled water as
the manufacturer has advised. You might also need to add more coolant if your
laser demands it. It's crucial not to overfill the tank, though. Don't overfill
your laser by adding too much coolant. This may cause water to flow out of the
reservoir, come too close to important electronics, and cause damage.
Check the pulses of the flash lamp
Track each wavelength's flash lamp pulses. It is advised
that you switch out the bulbs after 500,000 pulses. Purchase fresh flashlights
as needed.
Check Voltage
Check to see if the voltage tab in the laser system and
the voltage in the wall are in sync. Although most facilities vary and the wall
voltage might be as low as 200v or as high as 250v, a laser system normally
works on 220v.
Maintain a cool treatment area.
Maintain the lowest feasible room temperature for your therapy. Air cooling is used to cool the laser system and related chiller. Overheating issues might happen in rooms that are over 75 to 80 degrees. Many prefer to go for Cutera Repair.
Follow us on Twitter
No comments:
Post a Comment